Well pump replacement cost
Replacing a well pump costs about $1,900 on average, and most homeowners pay between $974 and $2,821. The pump type and well depth drive the price; deep submersible and constant-pressure systems cost the most.
Quick answer
$1,897national average
Most well pump replacements cost $974 to $2,821 with labor. Simple shallow jet pumps start near $200 for the pump, while solar and constant-pressure systems reach $5,800 or more.
Cost by pump type
Type prices cover the pump and typical installation. Deeper wells take longer to pull and need more wire and pipe.
| Pump type | Typical cost |
|---|---|
| Shallow well jet pump (under 25 ft) | $230 – $1,000 |
| Submersible pump | $275 – $1,550 |
| Deep well jet pump (up to 150 ft) | $440 – $1,200 |
| Constant pressure system | $2,000 – $5,000 |
| Solar pump | $1,800 – $6,500 |
| Hand pump | $150 – $1,500 |
Labor, pressure tank and repairs
| Item | Typical cost |
|---|---|
| Installation labor | $250 – $1,000 |
| Hourly labor | $45 – $150 |
| Pressure tank replacement | $800 – $3,800 |
| Permit | $50 – $200 |
| Well pump repair | $500 – $1,000 |
What plumbers charge for this job
Most of the price of a plumbing job is labor. Licensed plumbers in the U.S. typically charge $45 to $150 per hour, and many add a $50 to $200 service call fee that often covers the first hour. Expect evening, weekend and holiday visits to cost noticeably more; emergency hourly rates commonly run $150 to $350. Master plumbers and plumbers in high-cost metro areas sit at the top of these ranges.
Before work starts, ask whether the quote is a flat price for the whole job or an hourly estimate, and whether parts, permits and haul-away are included. See Plumber rates per hour and Emergency plumber cost for the full breakdown.
Signs your well pump is failing
- No water, or water that sputters
- Low or fluctuating pressure
- The pump runs constantly or cycles on and off quickly
- Higher electric bills
- Dirty or sandy water
Rapid cycling is often a pressure tank or switch problem, which is cheaper to fix than the pump.
DIY or professional?
Pulling a submersible pump from a deep well needs special equipment and electrical work. Jet pumps above ground are simpler, but most homeowners hire a well contractor or plumber to size the pump correctly.
How to save
- Have the pressure switch and tank checked before replacing the pump.
- Match the pump to your well depth and flow rate; oversizing wastes money.
- Get quotes from at least two well specialists.
Frequently asked questions
How long does a well pump last?
Typically 8 to 15 years, depending on pump type, water quality and how often it cycles.
How much does it cost to pull a well pump?
Labor to pull and reinstall a pump usually falls within the $250 to $1,000 labor range, more for very deep wells.
Sources
Prices are national estimates for 2026 based on published cost surveys and labor data. Your local price can be higher or lower. FairFix Costs is not a plumbing contractor; read our disclaimer.